Builder's Best P-Tanium 110889 Dryer Vent Hood, 6 in W Hood, 6 in H Hood, 4 in Duct

Listed and labeled as UL foil dryer transition duct. Steel wire supported, multiply design of aluminum and polyester. Dryer manufacturers do not recom..

Thicker and more durable. 4 in x 10-1/2 in Fully assembled, riveted tailpipe, backdraft flapper. Wide mouth for excellent airflow...

For dryer venting. 4 in aluminum Snap-Lock fittings clamp to standard connections or snap without clamps to other Snap-Lock fittings. Compressed to 24..

4 in aluminum soft-cuff on both ends. Pre-treated ends are ready to clamp to other components. Sturdy construction meets dryer manufacturer specificat..

UL 181, Class 1 air connector label for general venting. Multiply design of metalized polyester with 1 in pitch steel wire support...

UL 181, Class 1 air connector label for general venting. Multiply design of metalized polyester with 1 in pitch steel wire support...

Plastic vent hood faceplate with one-piece flapper for clothes dryer and bathroom venting. Fits 4 in aluminum pipe (not included). Beveled and weighte..

Silverduct™ UL® 2158A clothes dryer transition duct provides flame resistance. It crushes easily behind the dryer and is held together with layers of ..

Elbow turns 90 deg within 4 in. One male rotating snap-lock fitting, one female rotating snap-lock fitting. For 90 deg turns, especially on the dryer...

Use when outlet pipe on dryer protrudes up to 2-1/2 in. Can also be used where wall outlet pipe protrudes and is too large for the wall offset elbow. ..

SAF-T-DUCT® Periscopes are 2 x 6 in rigid aluminum with 4 in draw-band collars and Snap-Lock™ crimped fittings. These periscopes reduce the space need..